Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation since 11/18/2018 in Blog Entries

  1. 1 point
    Detail section 17  installing the first bit of trilam on the skyreach bushcat. ive never been good at lacing my shoes so this will be a challenge 😄 but at least I can make it easier to thread the lace with some superglue on the end and rolledbetween wet fingers to make a ‘needle’
  2. 1 point
    Note: this build is for the taildragger version of the Skyreach Bushcat, so bear in mind some sections may be a little different to the tricycle version. So I won't be posting every time I screw a nut onto a bolt. Mostly I will highlight points of interest, tricks and solutions and general thoughts. Also I am discovering that I am needing 'special' tools sooner than anticipated, so in this first post I will list any special tools/materials and the section of the Bushcat build I first needed them in. That way if anyone else is building a Skyreach Bushcat they can see when they have to spring for them without having to buy them all at once. At the time of writing this, I was up to section 17. I would suggest it won’t take long to get that far. Torque seal - Section 1 Pop rivet gun - Section 2 (not really a special tool as such, but I didn't have one handy so it goes in the list!) Loctite 243 - Section 12 Cable tension gauge - Section 14 0.82 safety wire - Section 14 (choose any unit of measure you like- miles, parsecs, cubits. I myself went for millimeters as that will have the best fit in the hole) modified pointy nosed pliers - Section 17
  3. 1 point
    This is an item I wrote a few years ago which was hard to upload due to the limitations of the forum. Old Man Emu A Practical Guide to Rib Lacing using the Modified Seine Knot.pdf
This leaderboard is set to Melbourne/GMT+11:00
×