airangel
Members-
Posts
107 -
Joined
-
Last visited
Information
-
Country
Australia
airangel's Achievements
Well-known member (3/3)
-
Great stuff.....................More please
-
Hello from Melbourne, Oz, Flight Design CTLS
airangel replied to Robert W's topic in Just Landed - Welcome
I guess you would know that Flight Design has gone broke. Reported that they are now made in Taiwan. -
Billet inclusion
-
Too much water
-
Go check the Rotax ADs. From memory they was some issues with fuel permeating the floats causing them to sink a little. I think there was a test one could perform to check this.
-
Meet the new cast for Hogans Hero's 2015
airangel replied to planedriver's topic in Aviation Laughter
Pls take this off. Its offensive -
Check,[wiggle the terminal block going into the regulator], i found poor connections at this point caused similar red light problems
-
Press the translate button
-
CASA - Draft Proposal for Jabiru Aircraft
airangel replied to slb's topic in AUS/NZ General Discussion
There are more than two Ian -
OMG...Where did you get the bit about "most aircraft metals are hardened by heating to 500c and dunked in water"
-
Anyone care to offer an opinion on a 19 registered Jab 160 fitted with a Rotax 912s. [has been , and is currently registered] what will RAA say about this ? in the revised pattern of thinking
-
This so true, but I have found that surgically concealing the pill in a King George whiting fillet [$76 kg] works 2 out of 10 times.
-
Twin Engine Piper - forced landing at Aldinga
airangel replied to aj_richo's topic in Aircraft Incidents and Accidents
Why did someone spray out the rego numbers after the incident? -
Just go to Jabiru.......They have a Dyno
-
Do you have any estimates on the finished engine weight?