Rebel 676

G'day Ralph, Just the answer I was looking for! Thanks very much. The Icom and Bendix look like the same unit. My phone output is stereo (iPhone) so should I connect left to pin C and right to pin D and the ground to pin 4? The intercom is mono so that's all I'll get in the headset but at least I wont miss out on half the song / conversation. Cheers Aaron

Hey you beat me to it ... Dad I was going to ask the question here too. I like the look of these bluetooth units. About $260 US plus shipping. http://www.pilotblulink.com/ But that's too easy and I'd like to build something or install something a little more permanent. :book:In my research I found this info... I've found the wiring diagram for the A200 and can certainly wire up AUX audio input. http://www.rv8.ch/files/Icom%20IC-A200%20Installation%20Instructions.pdf page 5 shows the aux input pins. My thought is to make up a four pole input plug (3.5mm) to plug the iphone into, and the rear of the plug would connect to the relevant pins on the rear of the Icom. From the iphone cable the tip and ring 2 are left and right audio, ring three is ground and ring four is mic. http://pinouts.ru/PortableDevices/iphone_headphone_pinout.shtml as seen here. Is it as simple as connecting L/R Audio and ground from the 4 pin plug to aux inputs and then a jumper off the pilot mic to the mic on the iphone connector (or am I just dreaming) ? Any help from those electronics type gurus would be greatly appreciated. Cheers Aaron