Lyndon

Does that refer to the front panels. I did read read that in the manual early in the piece. Once again I'm only going by the video supplied in the kit ??? All very confusing.

Lyndon

Before I completely rivet it up some opinions please. Now is the time to get right. Thanks Lyndon

Once again on the outside. ??? Mmmm

As per Reg CD it's on the outside. That's what I went by

I can't open your file.but I I know what you mean .

Lyndon

I have the floor on the outside. Bugger. Mmm

About to rivet up the floor. From underneath it will look nice from outside. But under the carpet not so good. Or vice a versa. Is it riveted from inside or outside ???

Thanks Lyndon

All sorted. I had the front landing gear loneron upside down.

Yep I'm an idiot but I worked it out before any rivets

Lyndon

2 is below 1. I know this the manual states it.

I believe 2 is below 3 as my Reg videos.

But where is 1 in relation to 3. The Reg video shows below and above in two builds. Manual tells me nothing.

Thanks Lyndon

One shows this

I have Reg s video. Two builds. One shows this

Nothing conclusive bin the manual at all. But in my build video pics I was right first time. It goes on top .

Thanks Lyndon

So the way I have it now is correct. The manual generally has diagrams with how brackets and sheets are lined up but with this top bracket the manual is quite unclear. The frame tubes fit perfectly as I have them now.

Thanks Lyndon

Or ???

Little unclear here. The top skin is attached to something at a later stage. The top bracket is to be fitted now. Looks like the top skin is bent up and riveted to the top bracket in the corners ???? True or false ???

Lyndon

Sorted

Ta I have worked out it needs to on the rear as per the cut outs on the down sides of rib 8

Looks tight and needs to bent quite I bit to get the angle ??? Am I on the right track or ????

Thanks Lyndon

I'm having a break for a few weeks. Been bike riding and then hopefully in a few weeks my engine arrives. Then I can spend a few weeks on that. Be nice not to prime and rivet for a bit.

Lyndon

I think it's just not a real good manual. Be fine if you had a built a few or with friends that had. Getting by though quite well.

Lyndon

Conformation that the angular is on the outside. Yes I looked and the manual is not clear at all.

Thanks

Yep. My kit has the small trim tab in the manual. But the kit is supplied with the later trim. It also has some parts of the smaller trim. Thus my manual shows a complete different way to wire it. But then in another section it has the later wiring. My top skin has hole already in it for the grommet and wire. But it is in the very rear. Double checking before I go drilling again. Reg has informed me the manual for the vg was much improved for the xl. I think my kit and manual is during a time of change. But I do ask a lot of questions.

Thanks Lyndon

Thanks got all confirmed

Where does it come out on the rear fuse skin

No worries. Thanks. Where about s in the rear of the fuse